How To Reset Honeywell Water Heater 4 Flashes

0
How To Reset Honeywell Water Heater 4 Flashes

How To Reset Honeywell Water Heater 4 Flashes. The gas inlet of the heater is connected with the gas control valve. Replace the malfunctioning thermopile, bad gas control valve and its.

How To Reset Honeywell Water Heater 4 FlashesHow To Reset Honeywell Water Heater 4 Flashes
Honeywell flammable vapor sensor lockout reset Plumbing from www.reddit.com

If your whirlpool (or any other water heater) has a control valve that looks like this control then you maybe able to use this tutorial to reset the box. Wait for 10 seconds and turn the knob again to set it on the ‘hot’ setting for 10 seconds. Lastly, turn the knob to ‘pilot’ for 10 seconds.

Table

Restart The Water Heater And See.

I called whirlpool customer service, got the replacement valve for $30. Turn the gas control knob clockwise to very hot position and wait 10 seconds. Set the knob to the.

Follow The Solutions Below And Make Sure Your Honeywell Heater’s Status Light Is Blinking.

Your code light will begin blinking. If your whirlpool (or any other water heater) has a control valve that looks like this control then you maybe able to use this tutorial to reset the box. You can reset the water heater by lighting the pilot and turning the knob to “very hot” for ten seconds, “hot” for ten seconds and to “pilot” for 10 seconds.

If The Pilot Wont Stay Lit Check This Video Out First.

Honeywell hot water heater status light blinking 7 times in red mainly indicates the gas control or valve failure. In this particular instance it was a 7 blinks (gas control failure. I’ll show you how to fix the honeywell.

First, Turn The Temperature Control Knob To The “Off” Position And Wait 5 Or 10 Minutes.

After less than 4 yrs of having the whirlpool water heater, i got 4 flashes. Turn the temperature control knob to the “off” position. Regardless what i tried, it was still 4 flashes.

Hot Water Heater Not Working.

Replace the malfunctioning thermopile, bad gas control valve and its. Follow the steps below to reset the 7 flashes of the status light on honeywell: Just follow these quick steps to fix the problem:

READ this  Dog Throwing Up Water And Diarrhea